Sos Brakes

[clarkey]

Guys need new discs ,Honda 954 ,Standard the way too go or is there an aftermarket(hopefully cheaper) option??Who is a good supplier??:confused1: :confused1:

[j-rad]

After market due to cost of genuines.......
I ran BRAKING Wave Discs - LOVED THEM........I used this brand because of the traditionally soft material the Suzuki discs are made of, causing them to warp badly with mis matched pad materials.......(SBS, EBC etc...) I went through 6 Standard discs before changing to Braking (partly due to stunting/stoppies I guess), never had another problem.

Total cost for 2 discs was $800.........+ 100 for the larger, Braking Pads.....

I've been told the Galfer jobs aren't quite as good, but not used em so not willing to comment........

[jasonbw]

929 have the same size dont they? Turtle or zRoYz will know.

[KTM_Paul]

http://www.metalgear.com.au/

[clarkey]

After market due to cost of genuines.......
I ran BRAKING Wave Discs - LOVED THEM........I used this brand because of the traditionally soft material the Suzuki discs are made of, causing them to warp badly with mis matched pad materials.......(SBS, EBC etc...) I went through 6 Standard discs before changing to Braking (partly due to stunting/stoppies I guess), never had another problem.

Total cost for 2 discs was $800.........+ 100 for the larger, Braking Pads.....

I've been told the Galfer jobs aren't quite as good, but not used em so not willing to comment........

HOPE YOUR WRONG (about the galfers haha )JRAD!!!!!!!!!!!!!!!!!!!!

[Turtle]

For the 954 "GALFERS" are the way to go but expensive......929 disks are the same as 954..

[clarkey]

I now your right turtle-cheaper than standard though and ive run outa options:cursing: :cursing: :cursing: :cursing: :cursing: :cursing:

[jasonbw]

eBay USA? arent there any there???

[Turtle]

eBay USA? arent there any there???

Yeah they would be....usually about $465 US+shipping....Good luck matee....

[Turtle]

you cold always contact SumOfAllParts and see what Donovan can do for ya ??

[Turtle]

you could always contact SumOfAllParts and see what Donovan can do for ya ??

[zRoYz]

Galfers are fine the rotors to stay away from are EBC the rotor material they use is second rate & your rotors will grove up if used hard very quickly.

There is a mod in melb that if you send them your complete carrier/rotor they will fit new rotors using good quality material cut into any shape you want, think they av in two wheels.

[Squirts]

i'm running the EBC contour rotors on my blade these days - not a problem at all.... pulls up hard at the track and have found i can leave braking a little later...

EBC Contour rotors - front USD$179.00 each / rear USD$119.00 each. allow approx. USD$50.00 for the postage..

if you can fit up a pair of original rotors of an 06 CBR1000RR i got my old ones in the garage... they done 16,000km's before i changed them out for the EBC's..